Instructions / Assembly

STEP 4 — CONTINUED

• Locate o-ring (3) in bag with various parts.

• Lubricate with o-ring lube to ensure proper seal

on tank.(O-Ring lube not included)

• Push o-ring against the lip of the valve. It MUST sit

flat against the lip to protect from leaking at the valve.

• Clean off any sand or debris on top lip of filter and

position valve over the opening of the standpipe.

• Valve will slide ONTO standpipe when positioned

properly in tank (as shown). Push down firmly to make

sure valve slides on all the way

NOTE

You CANNOT pull standpipe up to secure the valve.

Pulling up can damage the hub and cause sand to get

sent back with water flow to pool.

• Place valve so that pump port is directly

over the pump.