Operating Guide

18www.AquaProducts.com/Service
CHANGING DRIVE TRACKS
Drive Tracks (Fig. 22a) may become worn over the normal course of use and
will require replacement based on the frequency of use, the pool’s chemical
balance, pool surface and length of season. Worn (stretched, loose or “flat-
spotted”) Drive Tracks will impede your cleaner’s ability to climb stairs and
obstacles and may effect the cleaning pattern impeding its ability to cover the
entire pool. If during your periodic inspection you find that your Drive Tracks
are worn, please contact your Aqua Products Authorized Dealer for replacement
Drive Tracks or visit AquaProducts.com
1. Unplug your cleaner from its Power Supply and remove your cleaner
from the pool.
2. Place your cleaner on its side, on a soft surface which will not scratch the
Body’s finish.
3. With your thumbs pushing against the Side Plate (Fig. 22b), hook your
fingers under the Drive Track and pull it toward the Side Plate. When you
get the Drive Track over the “lip” of the Side Plate, hold it there with one
hand, and with the other hand, grip the Wheel Tube (Fig. 16) and rotate it
away from the cleaner until the Drive Track “walks” over the Side Plate.
Continue this until the Drive Track is free (Fig. 22b).
4. To mount the new Track, hook it around the lower Wheel Tube end and
pull it upward as you guide it between the cleaner’s Body and Side Plate.
5. Push inward on the Drive Track and force it over the edge of the Side
Plate. Rotate the Wheel Tube, towards you, until the Drive Track
properly seats itself on the Wheel Tube between the Side Plate and the
cleaner’s body
6. Repeat steps 1 through 5 with the Drive Track on the other side of the
cleaner.
Figure 22b
Figure 22a
Standard
Drive Track
G-Tooth™
Drive Track
CHANGING DRIVE BELTS
Drive Belts (Page 19; Fig. 26a, 26b) may become worn over
the normal course of use and will require replacement
based on the frequency of use, the pool’s chemical balance
and length of season. Worn Drive Belts will impede your
cleaner’s ability to move or climb and may effect the cleaning
pattern impeding its ability to cover the entire pool. If during
your periodic inspection you find that your Drive Belts are
stretched, loose or “flat-spotted please contact your Aqua
Products Authorized Dealer for replacement Drive Belts or
visit AquaProducts.com.
1. Remove Drive Tracks (See CHANGING DRIVE TRACKS).
2. Place the cleaner on a non-abrasive surface and turn
cleaner upside down. Remove Bottom Lid Assembly
(Fig. 23).
3. Remove the Wheel Tube Retaining Rings (Fig. 24a, 24b).
4. Locate and remove 4 screws (see Figure 25) on Drive
Motor side, which holds Side Plate in place.
Figure 23
Figure 24a Figure 24b
Wheel Tube Retaining Ring
“E” Clip “C” Clip
TIP! We suggest using needle nose pliers to remove
the Wheel Tube Retaining Rings.
IMPORTANT: When ordering replacements specify the type of Track
you are replacing; i.e. “Standard” or “G-Tooth™” Drive Tracks
IMPORTANT: Always replace both Tracks at the same time! Replacing
only one will adversely effect the cleaner’s cleaning pattern!