NE122SS STAINLESS STEEL IN POOL LADDER ASSEMBLY AND INSTALLATION INSTRUCTIONS
Parts Identification STEP 1 Unpack box and check parts against parts list below.
STEP 2 • • • • • Slide 1 of the 4 ladder steps onto one of the stainless steel handrails. See figure 1 Make sure that the step treads are facing up. If you have any difficulty sliding the step onto the handrail apply a small amount of oil to the handrail. Align the holes in the step with the top set of holes on the handrail. Secure step to handrail with a bolt and nut. Make sure that the head of the bolt is located on the outside of the step.
STEP 4 • Slide 1 pivot ball onto the bottom of each handrail Make sure both pivot balls are securely fastened to each handrail. See figure 4 • Figure 4 STEP 5 • • • Place the bottom step on the floor facing up Hold the ladder assembly straight up and align the pivot balls with the receivers on the bottom step. Push down firmly until both balls are inserted into the step. See figure 5 Figure 5 D STEP 6 Ladder Placement - Figure 6 • Locate ladder in desired position on deck.
