Owners manual

STEP 1

• Place the bottom step (D) on a level surface with

indentations facing up.

• Take leg (B) and stand upright (pointy side down).

When installed on bottom step, the leg will need to

have the raised areas facing inward. The raised

area with the pre-drilled screw hole should be at the

front of the ladder toward the top of the leg.

• Place the left leg into the indentation on the left

side of the step and push straight down until it

clicks into place.

• Repeat above for right leg on right side of step

STEP 2

• There are two sets of lug locations on the legs (B)

in the areas where each step will be installed.

Each step should be installed into the UPPER set

of lugs only.

• Locate one of the four groups of lugs and slide step

(A) into the set of lugs on the legs so it clicks into

place.

• Repeat for each of the remaining (3) steps.

• Secure the top step ONLY by screwing

(1) 10 x 1-1/4” screw into each side of the step

through the pre-marked leg openings.