Owners manual

11
NOTE
When a Ladder is installed
it is recommended that
a Step Mat should be
installed underneath.
THIS ITEM IS SOLD SEPARATELY.
• Line the two holes up on the top rail of
the pool. With a fine tip marker mark the
location of the holes.
• Using a 5/16” drill bit, drill two holes in
the ledge of the pool.
• For 48” pools use mounting kit AC 12001.
This consists of (2) 5” bolts, nuts and
washers.
• For 52” pools use mounting kit AC 12002.
This consists of (2) 2-1/2” bolts, nuts and
washers.
• For 54” pools use mounting kit AC 12002.
This consists of (2) 2-1/2” bolts, nuts and
washers.
• Attach the ladder to the pool sliding the
mounting hardware through the platform
• Tighten the nut and make sure the ladder
is secure.
• All pool ladders are required to be secured to the frame of the pool.
• There are 2 OPENINGS in the platform of the ladder.
• Place assembled ladder inside the pool where you would like to enter
and exit. The entrapment barrier should be inside of the pool.
• Once the ladder is placed in the pool, tip the ladder forwards and
backwards and side to side to release any air that may be trapped inside.
STEP 13
STEP 12