Owners manual

STEP 5

STEP 4

• Place the bottom step (D) on a level surface with

indentations facing up.

• Take leg (B) and stand upright (pointy side down).

When installed on bottom step, the leg will need to

have the raised areas facing inward. The raised area

with the pre-drilled screw hole should be at the front

of the ladder toward the top of the leg.

• Place the left leg into the indentation on the left side

of the step and push straight down until it clicks into

place.

• Repeat above for right leg on right side of step

• There are two sets of lug locations on the

legs (B) in the areas where each step will be

installed. Each step should be installed into

the UPPER set of lugs only.

• Locate one of the four groups of lugs and

slide step (A) into the set of lugs on the legs

so it clicks into place.

• Repeat for each of the remaining (3) steps.

• Secure ALL STEPS by screwing

(1) 10 x 1-1/4” screw into each side of the

step through the pre-marked leg openings.

NOTE

STEP 4 IS SIMILAR TO STEP 1

NOTE

No Step Connectors are used

in this step