Owners manual

STEP 8 — ATLANTIS ENTRY SYSTEM

• To attach the ladder to the step assembly,

you will need to attach the shield (I).

• Line the shield up above the handrail and

push it down so it slides onto the handrail.

Repeat for opposite side.

• Rotate shield 90 degrees, so that the open

sleeve of each shield is on the outside

(see photo).

STEP 9

• Once shields are situated properly, lift ladder up

and line up the openings of shield with long

handrail posts of the step.

• Slide the ladder down until it rests on ground

outside.

• Coat adjustable tube (C) with lubricant and slip

(1) mounting block (B) all the way down over the

nubs on the tube. The open side should be

exposed.

• Repeat for second adjustable tube and mounting

block.

• Push one adjustable tube into the longer part of each

handrail. The mounting block should sit on the top

step to hold the ladder in place. Secure into handrail

using (4) #10 1-1/4” screws in pre-marked openings.

• Secure each mounting block to the top step of the

staircase using (4) 10 1-1/4” screws per mounting

block.

• Fasten the shields to the handrails using (8)

#10 1-1/4” screws (4 per side).

OPEN

END