Owners manual

STEP 1

• Place the bottom step (G) on a level surface with

indentations facing up.

• Take leg (E) and stand upright (pointed side down).

When installed on bottom step, the leg will need to have

the raised areas facing inward. The raised area with the

pre-drilled screw hole should be at the front of the ladder

toward the top of the leg.

• Place the left leg into the indentation on the left side of

the step and push straight down until it clicks into place.

• Repeat above for right leg on right side of step.

STEP 2

• There are two sets of lug locations on the stringers

in the areas where each step will be installed.

Each step should be installed into the UPPER

set of lugs only.

• Locate one of the four groups of lugs and slide step

(A) into the upper set of lugs on the legs so it clicks

into place.

• Repeat for each of the remaining (3) steps.

• Secure all by drilling (1) 10 x 1-1/4” screw into

each side of the step through the pre-marked

leg openings.