STEEL TREAD REVERSE BEND STAINLESS STEEL LADDER NE1149 TOOLS REQUIRED • Phillips head screwdriver • Rubber mallet (optional) • 1-1/2” hole saw • Pencil or chalk • Pliers 7938
STEEL TREAD STAINLESS STEEL LADDER PARTS 1 3 2 4 PART # 2 MODEL # 5 REORDER # DESCRIPTION QTY 1 AC 73008 NEP2192 Stainless Steel Handrail 2 2 AC 22411 NEP2045 Ladder Steps 4 3 AC 22268HDW NEP2047 Hardware Bag 1 4 BS STPBALL NEP2193 Pivot Balls for Base Step 2 5 AC 22438 NEP2046 Bottom Step 1
STEP 1 • Locate both rails (AC 73008) and stand them up with the curved ends at the top. • The rails are interchangeable, it does not matter which one is placed on the right or left. There are four sets of holes on the rails and the steps may be installed in any order. • Insert one step (AC 22411) between the two rails and line up the holes on the sides of the step with a set of the pre-drilled holes on the ladder. Make sure the treads are facing up towards the curved part of the rails.
STEP 3 • Push one pivot ball (BS STPBALL) onto the round bottom opening of the ladder. The rounded end should face downward. • You may need to use force or gently tap the pivot ball into place with a rubber mallet to get it properly positioned. • Repeat for second rail and other pivot ball. • Check to ensure that both pivot balls are fastened securely as these are what hold the ladder onto the bottom step.
STEP 5 A D C • Place ladder in your desired position on deck (A). Swivel step if needed to align with pool floor. Make sure the base step rests flat against the pool floor. (B) • Mark the location of the handrails on the deck with a pencil. Using a 1 ½” hole saw, drill one hole for each hand rail through the deck surface (c). This will ensure that the deck will now support the ladder. • Secure hand rails to the deck using deck flanges (D). • Slide the flanges over each handrail.
LADDER MATS • The use of a ladder mat is strongly recommended with any pool ladder. Ladder mats prevent your pool liner from being damaged by slight movements of your pool ladder. USE MODEL NA400 9” x 30” MAT HOW TO INSTALL YOUR LADDER MAT 1. Remove ladder mat from packaging 2. Place ladder mat onto the bottom of the pool with the smooth side facing down towards the liner 3. Place fully assembled ladder on top of the ladder mat. Make sure the ladder is centered on the ladder mat 4.
LADDER FLANGES • Ladder Flanges are used to secure your ladder to your deck.
