PLASTIC TREAD REVERSE BEND IN POOL LADDER W/RESIN NE1147 TOOLS REQUIRED • Phillips head screwdriver • Rubber mallet (optional) • 1-1/2” hole saw • Pencil or chalk • Pliers
PLASTIC TREAD STAINLESS STEEL LADDER PARTS 1 3 5 4 2 PART # 2 MODEL # REORDER # DESCRIPTION QTY 1 AC 73008 NEP2192 Reverse Bend Stainless Steel Handrail 2 2 BS STPBALL NEP2193 Pivot Balls for Base Step 2 3 BS MIDSTEP NEP2043 Ladder Steps 4 4 BS BOTSTEP NEP2044 Bottom Step 1 5 BS 698HDWR NEP2194 Hardware Bag 1
STEP 1 • Slide one of the four ladder steps(BS MIDSTEP) onto one of the stainless steel handrails (BS SSRAIL). Make sure that the step treads are facing up. (See figure 1) • If you have any difficulty sliding the step onto the post, apply a small amount of lubricant to the posts. Figure 1 STEP 2 • Slide the second handrail thru the hole on the opposite side of the step. • Align the holes in the step with the top set of holes on the handrail.
STEP 4 • Slide the pivot balls (BS STPBALL) onto the bottom of each handrail as shown in figure 4. • Make sure both pivot balls are securely fastened to each handrail. Figure 4 STEP 5 • Place the bottom step(BS BOTSTEP) on the floor facing up. Hold the ladder assembly straight up and align the pivot balls with the receivers on the bottom step. • Push down firmly until both balls are inserted into the step. See figure 5. Figure 5 STEP 6 A D C • Place ladder in your desired position on deck (A).
LADDER MATS • The use of a ladder mat is strongly recommended with any pool ladder. Ladder mats prevent your pool liner from being damaged by slight movements of your pool ladder. USE MODEL NA400 9” x 30” MAT HOW TO INSTALL YOUR LADDER MAT 1. Remove ladder mat from packaging 2. Place ladder mat onto the bottom of the pool with the smooth side facing down towards the liner 3. Place fully assembled ladder on top of the ladder mat. Make sure the ladder is centered on the ladder mat 4.
LADDER FLANGES • Ladder Flanges are used to secure your ladder to your deck.
