Owners manual

ManualsBrandsBlue Wave ManualsPool AccessoriesPremium Stainless Steel In-Pool Ladder for Above Ground Pools

SUPER STAINLESS STEEL

IN-POOL LADDER

This ladder is designed for use with

a deck to provide entry into the

pool for 48” and 52” aboveground swimming pools. DO NOT attempt

to use this ladder without a deck as injury may occur.

TOOLS REQUIRED

• Phillips head screwdriver

• Rubber mallet (

optional)

• 1-

1/2” hole saw

• Pencil or chalk

• Pliers

MODEL NE1145

Summary of content (5 pages)

PAGE 1
SUPER STAINLESS STEEL IN-POOL LADDER This ladder is designed for use with a deck to provide entry into the pool for 48” and 52” aboveground swimming pools. DO NOT attempt to use this ladder without a deck as injury may occur.
PAGE 2
PARTS FOR LADDER A. STEP (4) B. BOTTOM STEP C. PIVOT BALL (2) D. HARDWARE (NEP2045) (NEP2048) (NEP2046) (NEP2047) • • (8) bolts (8) nuts E.
PAGE 3
Step 1 • Locate both rails (E) and stand them up with the curved ends at the top. • The rails are interchangeable; it does not matter which one is placed on the right or left. There are four sets of holes on rails and the steps may be installed in any order. • Insert one step (A) between the two rails and line up the holes on the sides of the step with a set of the pre-drilled holes on the ladder. Make sure the treads are facing up towards the curved part of the rails.
PAGE 4
Step 2 • Push one pivot ball (C) onto the round bottom opening of the ladder. The rounded end should face downward. • You may need to twist, push and/or hit the pivot ball into place with a rubber mallet to get it properly positioned. • Repeat for second rail and other pivot ball. • Check to ensure that both pivot balls are fastened securely as these are what hold the ladder onto the bottom step. Step 3 • Place the bottom step (B) on a hard, level surface with the recessed areas facing upwards.
PAGE 5
Step 4 • Decide where you would like to enter the pool from your deck. • Position ladder with curved part of rails in the area of your choice. The design of the bottom step allows it to swivel to fit against the cove of virtually any pool. If necessary, swivel step so that it sits against pool floor. NOTE: It is recommended to install a ladder mat underneath the bottom step to protect the liner. Visit your local pool dealer to purchase this item as it is sold separately.