Operating Guide

YOUR POOL STEP WEIGHS 100 PLUS POUNDS WITH THE REQUIRED SAND IN THE SIDE PANELS. IT WILL
REQUIRE 2-3 PEOPLE TO LIFT STEP OVER POOL SIDE WALL.
IF STEP IS BEING USED WITH OUTSIDE SAFETY LADDER MODEL # 400900 REFER TO SAFETY LADDER
INSTRUCTIONS FOR PROPER ATTACHMENT TO LADDER.
1: Remove the two white caps from the side
panel fill holes. Carefully lift pool step over
pool wall being careful not to damage pool
liner or pool frame.
#2: Step will float until the air is out of step
components. To remove the air, tilt the step to
the left unitl the fill hole in side panel is under
water. Keep tilted until all air bubbles stop then
cap fill hole. Next tilt the step to the right until
all air bubbles stop then cap fill hole. At this
time, the step should be sitting firmly on bot-
tom of pool. If not, air is still trapped in compo-
nents and step will have to be tilted again.
#3: If step is being used with pool deck
rotate the two deck connectors to sit on to
pool deck and attach using two - #10 x 1-1/4”
self tapping screws in each connector.
#5: Apply the two safety labels on the upper
handrail posts so they are visible when enter-
ing the swimming pool.
#4: Attach the deck connectors to the
handrail posts using two - #10 x 1-1/4” self
tapping screws.
INSTALLING STEP INTO SWIMMING POOL
prpd.RG-OB-Steps-USr10:Layout 1 12/16/10 9:15 AM Page 5