Operating Guide

3: Position a step tread over the riser and
into the slots on the side panel. With a rubber
mallet tap tread down until locked into place.
It will require several hard hits with a rubber
mallet.
#4: Place the next riser into the slots on the
side panel just above the tread and push
down until seated. Air vents must be facing up.
#5: Place a locating tread into the slots and
over the riser. With a rubber mallet tap tread
down until locked
into place.
#6: Install one more locating tread, one
more step tread and two risers.
#7: Place the second panel over the risers
and step treads making sure to align all the
tabs on the side panel. Using a rubber mallet
tap down on the side panel until all treads
are locked into place. It will require several
hard hits with a rubber mallet.
#8: Position a foot pad over the round
extension located on the bottom of side
panel. It will require several hard hits with a
rubber mallet to force the foot pad over the
extension. Repeat to install the three
remaining foot pads. Stand the step upright.
STEP ASSEMBLY: (Cont’d.)
prpd.RG-OB-Steps-USr10:Layout 1 12/16/10 9:15 AM Page 3