Instructions / Assembly

No Diving or Jumping. Observe all Safety Rules
1-31
GENERAL INSTRUCTIONS - YARDMORE OVAL POOLS
GROUND PREPARATION
Sec on
1
E. ASSEMBLING THE BUTTRESS STRAPS AND PRESSURE PLATES
f. Once both sides of the buttresses have been
installed perfectly, check that all is measured
perfectly.
g. Add the remaining straps that join across to other
straps. Make sure the screw heads are facing
upward. Remeasure and tighten screws. Recheck
measurement again. (Images 25 & 26)
h. Measure the two intersecting axes to ensure that
the two straight sections are parallel. (Image 27)
2. Proceed to Section 2 -
Assembling the Pool Base
25
Note:
It may feel tedious to be always measuring, but this
only helps to ensure proper installation and avoiding
problems further on.
27
Important Note:
Ensure that the straps raise higher in the middle,
therefore you may need to put a little more stone dust
underneath, appx 1/2".
26