Instructions / Assembly

No Diving or Jumping. Observe all Safety Rules
2-4
Sec on
2
GENERAL INSTRUCTIONS - YARDMORE OVAL POOLS
ASSEMBLING THE POOL BASE
A. CONT. INSTALLATION OF OF BOTTOM PLATES AND BOTTOM RAILS
8
4. Measure the perimeter of your pool
a. Measure the perimeter of your pool and hammer
nails into the ground to keep the bottom rails into
place. These nails are to be removed only at the
last step-when filling up the pool. (Image 8)
b. Verify the height of each bottom plate with an
optical level. Ensure that they are the same height.
5. Fill inside the pool area
a. Pour sifted sand in the centre of your pool. Ensure
that you will have enough to spread approximately
2" (2.5cm) around the inside pool area. (Image 9)
b. Spread the sand inside the pool area. Make sure
not to spread the sand onto or beyond the bottom
rails. Compact the sand manually or mechanically.
2. Proceed to Section 3 -
Assembling the Pool Wall
Important Note:
Use a soft measuring tape to meaure around the perimeter of
the pool. Measure from the inside of the bottom rail, the mea-
surement should equal the wall length.
Important Note:
9