Instructions / Assembly

No Diving or Jumping. Observe all Safety Rules

1-30

Sec on

GENERAL INSTRUCTIONS - YARDMORE OVAL POOLS

GROUND PREPARATION

E. ASSEMBLING THE BUTTRESS STRAPS AND PRESSURE PLATES

1. Assemble the buttress straps and brace

a. Place crushed stone or soil where the pressure

plates are located. This will have the effect of

supporting the pressure plate.

b. Put pressure plates on the tip of the strap end

channel to 20 1/2“ from the steel upright. The side

that is corrugated must be facing up and the flat

side facing the ground.

(Images 24 & 25)

c. For the alignment of the pressure plate there is a

hole at less than one inch from the edge of the

plate. This hole is facing the vertical part of the

steel structure. Once the plates are in position,

secure them to the channels using two #12 x 3/4“

screws. (Image 26)

d. Once all plates are secured to the channels, the

plates should overlap each other. Secure the plates

to each other using three #12 screws in each

overlapping area.

e. You may now go back to step 2-Digging the

buttress trenches, to continue for the remaining

side of the oval.

Important Note:

If the holes do not align, DO NOT drill holes! Verify the

alignment of the structures.

NOT GOOD

GOOD