Instructions / Assembly

DO NOT FASTEN THE WALL WITHOUT USING THE
REINFORCING WASHERS ! FAILURE TO USE REINFORCING
WASHERS AS INSTRUCTED WILL CAUSE WALL TO SPLIT
WHEN POOL IS FILLED. THIS CAN CAUSE SERIOUS
PROPERTY DAMAGE AND/OR BODILY INJURY.
INSERT THE SCREWS FROM INSIDE OF WALL.
NUT MUST BE FASTENED FROM OUTSIDE OF
WALL.
* Reinforcing Washers must be on INSIDE and OUTSIDE of wall.
* Insert the screws from INSIDE of the wall.
* Insert and fasten screws from hole to hole down to the bottom
of the wall.Do not fasten tightly before insert all screws.
* Fasten all screws tightly.
* Do not leave any open holes.
* Cover all the screw heads with strip of fabric tape.
* Check the level of the top of the wall,if more than 2" off level ,
Rework the ground to achieve levelness.
Build a mound 6" high and extending 8 to 10" on the
ground around the inside of the pool wall. Pack the earth
gently but firmly.
The earth mound must be built right. you must rebuild the earth
mound each time you set up the pool. Water pressure can force the
liner out under the bottom rail. If this is not done.This could cause
damage to the liner and void warranty. The earth mound will
prevent this from happening.
Bring the wall close to the bottom rail.
Make sure there is nothing in the bottom rail before
inserting the wall. If there is earth or something is in the
bottom rail,take out it accordingly.
Begin to insert end of wall into bottom rail. One person
unwinding wall (wall should be on a plywood base for
ease of rotating) while the other person is feeding wall
into slot of bottom rail around entire pool.
As you unwind the wall and insert it into the assembled
bottom rails, temporarily place top rail sections on top of
the wall. This will help to prevent the wall form bending
or falling over.
Should the wall be either too short or too long,Adjust
bottom rails,The circumference of bottom rails can be
adjusted slightly by equally tapping outward or inward at
the each lower joint until the wall ends meet.
Bring the two open ends of the wall together as shown
above.
This is one of the most important steps in assembling the
pool. Pay close attention to the following points.
There is an up and down side on steel wall. Locate the
skimmer cutouts which are near the outside end of the
wall. These cutouts must be at the TOP even if you will
not be using these cutouts .
Place coiled wall near bottom rail one section
open.
4) INSTALLING WALL
It is practical if two people work together; one inside and
one outside of the pool.
Due to the weight of wall,some bending will occur in the top and
bottom corrugation.because the wall is built to flex. Simply bend
those sections back before inserting wall in top or bottom rail.
Use Wall Joint Bolt Package packed in a Wall
Carton.
IMPORTANT:
Step 4:
STEP 1:
STEP 3:
Note:
STEP 2:
P.N.-0513
1/4 x 1/2in Truss Head Screw
1/2
P.N.-0611
1/4in Nut
5) BUILD AN EARTH MOUND(cove)
WALL
WALL
NUT
INSIDE OF POOL
BOLT
REINFORCING
WASHER
P.N.-0411
1/4in Reinforcing Washer
φ 1 3/8
3
1/4in Reinforcing Washer
1/4in Reinforcing Washer
1/4in Reinforcing Washer
1/4in Reinforcing Washer
INSIDE OF POOL
INSIDE OF POOL
2in
6in