Instructions / Assembly

No Diving or Jumping. Observe all Safety Rules.
CONT. C. INSTALL THE POOL LINER
16
Important
Note:
Do not trim off
the excess
liner. (If the
liner ever
needs to be
removed,
trimming the
liner will make
re - installation
very difficult.)
Instead, roll up
any excess
liner and tape it
in place near
the top of the
pool wall.
e. After all the wrinkles in the liner are
removed, trim any extra length of
plastic coping so there is no overlap .
(Image 4)
f. Roll up any excess liner hanging below
the plastic coping and tape it in place
near the top of the pool wall.
Important: Do not trim off the excess
liner. (Image 5)
3. Fasten the liner in place (BEADLOCK LINER ONLY)
a. Remove stabilizers gradually as you
install the liner receptors (A) onto the
wall. Hang the liner into the molded slot
(B) of the receptors. Secure the liner in
place with the locking device (C) .
(Optional)
6
4. Fasten the liner in place (HUNG LINER ONLY)
a. Remove the stabilizer gradually from
the top edge of the pool wall.
b. Hook the V - bead over the edge of the
pool wall .
c. Replace the stabilizer .
7
d. Repeat steps (a) to (c) until you have gone around the entire
pool and finished attaching the pool liner in place.
e. Start filling the pool with water. As the pool fills , work out all the
wrinkles and smooth the liner to the wall .