Instructions / Assembly

No Diving or Jumping. Observe all Safety Rules.
C. INSTALL THE POOL LINER
15
Important
Note:
If possible,
unfold the liner
on the grass
one to two
hours before
installation. Be
careful not to
leave the liner
too long or you
may damage
the grass.
1. Set the liner in place
a. Open the carton. Do not use anything
sharp to open the carton.
b. Unpack and unfold the liner and
spread it out in the sun to warm it up.
Inspect all the seams and surfaces for
holes.
c. Remove your shoes to avoid damaging
the base or tearing the liner.
d. Spread out the liner, smooth side
down. The curved seam should be
centred on the cove at the base of the
wall. The other seams will form
straight lines across the bottom of the
pool. (Image 1 & 2)
1
2
3
2. Fasten the liner in place (OVERLAP ONLY)
a. Remove stabilizers gradually as you
fold the liner over the top of the wall.
Note: We suggest an overlap of 6 ” to
8” (15 to 20cm). (Image 3)
b. Fasten the liner to the top of the wall
with plastic coping. Let the liner hang
slack for now. Do not pull the liner tight.
c. Turn the vacuum cleaner on and push the liner outward with
your feet to iron out any wrinkles. Once finished, turn off
vacuum cleaner.
d. Start filling the pool with water. As the pool fills, work out a ll
the wrinkles and smooth the liner to the wall. Remove the
plastic coping around the top edge of the wall one piece at a
time and adjust the liner. Keep smoothing out the wrinkles.
e. Smooth out all the wrinkles in the bottom.
Important
Hint:
The liner is
generally
smaller than
the support
structure of the
pool. It will
stretch more
easily when
warm. It is
important that
the liner is
installed on a
warm sunny
day.