Instructions / Assembly

No Diving or Jumping. Observe all Safety Rules.
B. CONT. ASSEMBLING THE POOL WALL & LINER
d. Cover the seam and bolt heads on the
inside/interior of the pool wall
completely with 2 ” (50mm) duct tape.
(Image 9)
13
Important
Note:
The pool must be
levelled within 1"
(25 mm) across
the diameter. A
pool that is not
levelled is
dangerous and
may collapse.
9
3. Make sure the pool wall is level.
a. Use a length of string and a line - level
to check across the top edge of the
pool wall to see if it is level. Check the
wall in several different directions. The
wall must be level. If the level is off by
more than 1" (25 mm) across the
diameter of the pool, take the wall
apart and level the foundation again.
(Image 10 & 11)
11
4. Make sure the pool wall is round
a. Using a tape measure, measure across
the circle at each bottom plate. The
pool wall must be round within 1" (25
mm) (all of the measurements must be
within 1" (25 mm) of each other).
Adjust the circle by nudging the base
plates in or out with your foot.
(Image 12)
b. Adjusting the pool to the proper shape
may cause the bottom rails and
bottom plates to slip out of alignment
a little. Recheck all of the bottom
plates to make sure each one is
centred where the bottom rails meet.
(Image 13)
12
13
10
13