Instructions / Assembly

No Diving or Jumping. Observe all Safety Rules.
A. ASSEMBLING THE POOL BASE
a. Place the bottom plates equally spaced
around the perimeter of your
foundation. Place one base plate on
each stone. (Image 1)
b. The bottom rails and the bottom plates
of the Aries pool are galvanized steel.
This means they have a silver colour.
DO NOT use the painted connectors
and rails. These go on top of the pool.
c. Insert the end of each bottom rail into a
bottom plate. Leave a gap of 2 - 1/8" (55
mm) between the ends of the bottom
rails. (Image 2, 3 & 4)
1. Lay out the bottom plates and bottom rails.
9
Section
2
1
2
3
4
d. Measure the diameter of your pool
all around the circle and make sure it
is correct. Note: this measurement
should be taken from centre to
centre of the bottom rail. When the
circumference is perfectly round,
hammer nails into the ground to
keep the bottom rails into place.
These nails are to be removed only
at the last step - when filling up the
pool. (Image 5)
5