Instructions / Assembly

No Diving or Jumping. Observe all Safety Rules.
B. ASSEMBLING THE POOL WALL & LINER
Do not attempt to install the pool wall in the wind, wait for a calm
day. It takes at least 3 people to install the pool wall.
a. Unpack the coiled pool wall and stand
it on a piece of cardboard or plywood
at the centre of the pool. The cut - outs
for the through - the - wall skimmer
should be towards the top of the wall.
( Image 1)
b. Start uncoiling the wall, guiding the
bottom edge into the curved bottom
rail. The starting end of the wall must
be positioned in the centre of a bottom
plate, and the skimmer and return
holes should be positioned where the
pump and filter will be. (Image 2 & 3)
c. Set lengths of stabilizer onto the top
edge of the wall as you uncoil it. We
also suggest installing vinyl - covered
hooks and rope to hold the wall
steady. Ideally the help of several
people should be solicited to hold the
wall in place. Work around the
foundation until the entire pool wall is
uncoiled into the bottom rails. (Image 4)
1. Set the pool wall in place.
11
Important
Note:
Bring the
following items
onto the pool
foundation
before you
start uncoiling
the pool wall:
cardboard or
plywood, some
extra sand to
make the cove
and a ladder to
climb out after
the wall is
assembled.
For best results , mount the skimmer on the downwind side of the pool (that is, directly
across from the most common wind direction).
Important Hint
Important
Note:
Make sure the
skimmer and
water return
holes are
located where
you need them
to be.
1
2
3
4