Full Product Manual

POOL ASSEMBLY INSTRUCTIONS (CONTINUED)

12. FOR 15’ & 18’ ROUND POOLS ONLY! Look through the hole in the vertical leg of the T-Fitting as you

insert the Vertical Leg. Rotate the leg until the holes in the Vertical Leg and the T-Fitting align.

13. Go around and check all ttings, legs, and beams are properly installed and secured in place. Make sure the

drain tting is plugged securely and the cap is in place.

14. Fill up the pool with about an inch (1”) [2.54cm] of water. Stop lling and smooth out all wrinkles from the

pool oor, working outwards from the center, so that it lls evenly.

Note: If more than one to two inches (1”-2”) [2.54cm-5.08cm] of water collects on any one side before the pool

starts lling in the center, the pool is not level enough, and must be corrected.

15. IMPORTANT! Before adding additional water you must install the thru-wall water intake and returns ttings

and connect the ltration system as per the ltration system instruction manual.

16. Once you have completed the assembly and attachment of the ltration system you can continue to ll the

pool. Add water to a minimum of six inches (6”) [15.24cm] below the top rim.

NOT FOLLOWING THE STEPS ABOVE WILL MAKE THE POOL FILL UNEVENLY. THE POOL MAY LEAN

TO ONE SIDE AND COLLAPSE. THE VERTICAL LEGS MUST BE STRAIGHT AND VERTICAL TO THE

GROUND. IF YOUR POOL IS LEANING, THE GROUND MAY NOT BE LEVEL AND YOU WILL NEED TO

START OVER.

DANGER! FAILURE TO FOLLOW THE GROUND PREPARATION AND ASSEMBLY INSTRUCTIONS ABOVE

WILL CAUSE YOUR POOL TO COLLAPSE, POSSIBLY CAUSING FLOODING DAMAGE OR INJURY TO

SWIMMERS. A POOL THAT COLLAPSES DUE TO NOT BEING LEVEL WILL VOID THE WARRANTY.