Full Product Manual

12
POOL ASSEMBLY INSTRUCTIONS
POOL LADDER ASSEMBLY
POOL ASSEMBLY INSTRUCTIONS (CONTINUED)
Before assembling your product, please take a few minutes to check out the contents and become
familiar with all the parts.
WARNING!
DO NOT overll the pool.
DRAIN the pool to the proper level after a heavy rain.
TIP: It will be much easier to install your pool if you unfold it and let it lay in direct sunlight for about
2 hours prior to installation. This will help to ensure a wrinkle-free t because the pool material will be
more pliable allowing it to form into the shape during installation.
1. Carefully unfold the pool liner in the area selected and inspect the seams for manufacturing defects.
2. LIFT the pool liner across the ground. DO NOT drag the liner from one location to another.
3. Locate the pool so that the pump opening is within the length of the electrical cord of the GFCI
protected electrical outlet.
Follow the assembly instructions that came with the ladder for your pool. Assembling the ladder now
will allow you to use it for access into and out of the pool during the liner installation process.
NOTE! Depending on the size of your pool, there will be different quantities of the frame
components. The diagrams below are for reference only.
6. Insert the Vertical Legs (3) into the Vertical Leg Caps (5)
7. Lay all the parts on the ground as shown below.
CAUTION! Position the liner with the openings for the
pump’s water connections facing the electrical outlet.
*Image for reference only.