Use and Care Manual

5
OPERATION INSTRUCTIONS
6. Turn on the water supply. This will cause a
venturi suction at the vacuum head. Debris
is collected in the vacuum bag.
8. When done or when the bag is full:
a) Slowly move the vacuum head to the side
wall of the pool, turn the vacuum head up-
side-down, shut off the water, and remove
the vacuum head from the pool.
b) Remove the vacuum bag and discard all of
the debris, ip the bag inside-out, and
rinse with running water.
7. Carefully, and slowly push the Vacuum Head
across the pool floor to remove debris. Do not
press hard on the liner as this may cause damage.
9. Repeat the above steps until the pool has been
cleaned thoroughly.
Vacuuming with Base Vacuum Head
1. Start with the Base Vacuum Head and attach it
to the telescopic pole as shown below.
2. Attach a 1.25" Vacuum Hose (Not Included)
to the Base Vacuum Head.
3. Attach the Vacuum Hose Adapter
(pictured below) to the open end of the
1.25" Vacuum Hose.