Installation Guide

7
7. TECHNICAL DATA & SPECIFICATIONS
8. UNPACKING YOUR FILTER SYSTEM
9. POWER SOURCE INSTRUCTIONS
1. Flow Rate: 1545 GPH
2. Pump is self-priming
3.
Maximum water temperature: 35°C (95°F)
4. 250W / 115V / 60HZ / 1/3HP
5. Tank diameter: 10’’
6. 1¼”-1½“ Hose connectors
7. (0.7 lbs) of cotton tails are included
8. For use with pools up to 12,000 gallons
Filtering time:
The swimming pool’s water should be circulated and ltered at least 3 to 5 times in a 24 hour
period, depending on the load and the size of the lter system. The time required is based on the
performance of the lter system and the size of the swimming pool. However, we recommend a
minimum running time of 10 to 12 hours per day.
Carefully remove the product and all component parts from the box. Cross reference all parts in the
box with the parts list reference chart to make certain all parts are present before beginning assembly.
NOTE: Some parts may be located within the lter tank. To access these parts, you must remove the
tank cover.
ATTENTION: Refer to Pages 11 and 12 for the previously mentioned parts list and diagrams.
1. The above-ground lter pump system you have purchased is equipped with a standard electrical
cord and plug which should only be connected to a power outlet protected by a 30 Amp Ground-
Fault-Circuit-Interrupter (GFCI) that has been installed by a professional electrician and adheres to
local codes and regulations.
2. To avoid electric shock, power cord extensions should NOT be used.