Installation Guide

6
ASSEMBLY INSTRUCTIONS FOR SAND FILTER
NOTICE
STEP 1
• Using a Phillips head screwdriver, remove the closure clamp (D) from the valve assembly. You only need to
unscrew one side completely as it can be removed and reinstalled without unscrewing both screws.
• Remove the valve (C) from the tank and place it to the side until instructed to reattach it.
• Inside the tank you will nd the standpipe (E) and a plastic bag
containing the laterals (F).
• Attach each lateral to the standpipe by pushing them into the
opening and turning to the right as shown in Diagram 1.
• Repeat for the remaining SEVEN laterals. See Diagram 2.
NOTE: You MUST install the laterals on the standpipe INSIDE the
tank as the standpipe will not t back through the top opening
once the laterals are attached. See Diagram 1.
DIAGRAM 1
DIAGRAM 2
The Filter is partially assembled; however, nothing has been properly tightened. DO NOT
operate the lter system without completing ALL assembly instructions.