Use and Care Manual

CAUTION: If your pool does not have pre-cut openings for the skimmer and return water tting

follow the Metal Wall Pool Manual for cutting the holes for the intake, water return, and skimmer box

housing connections.

1. Install the pool liner per the instructions in the Cobalt and Capri Pool installation manual.

2. Fill the pool with water between 1 to 2 inches below the position of the water return connector kit

hole. (See diagram 1)

3. Screw the water return connector kit (P6784) to the pool wall. Make sure the Teon tape is wrapped

and coats the thread of the water return connector. Screw the remaining parts of the water return

connector kit into position (see diagram 2).

NOTE: To stop the water ow, screw the plug (P6813) into the back of the water return connector

kit from inside of the pool wall (See diagram 3).

NOTE: When using the ltration system remove the plug (P6813) to allow water to ow to the lter.

WARNING! Never permanently install the skimmer, inlet, and outlet connector kits before the

water is within a few inches of them, the water pressure helps the liner to become properly sealed

against the wall and allows small adjustments to be made before nal installation.

WATER RETURN HOSE CONNECTION KIT INSTALLATION