Installation Guide

Expendable parts that do not fall under the warranty include:
 All O-rings
 Pressure gauge if this filter system is equipped with one
 Mechanical seal, complete
 Hoses and metal hose clamps
F. Resultant Damages
We cannot be responsible for damages to the product if the product is not used in accordance with the instructions
provided.
G. Technical Data and Specifications
1. Circulation power 1100 GPH
2. Pump is not self-priming
3. Maximum water temperature 35°（95°F）
4. 100W / 115V / 60HZ / 1/10HP
5. Tank diameter: 10’’
6. 1¼”-1½“ Hose connectors
7. (0.8 lbs) of cotton tails are included
8. For use with pools up to 3,000 gallon
Filtering time:
The swimming pool’s water should be circulated and filtered at least 3 to 5 times in a 24 hours period, depending on
the load and the size of the filter system. The time required is based on the performance if the filter system and the
size if the swimming pool. However, we recommend a minimum running time of 10 to 12 hours per day.
H. Unpacking your filter system
Carefully remove the product and all component parts from the box. Cross reference all parts in the box with the
parts list reference chart to make certain all parts are present before beginning assembly.
NOTE: Some parts may be located within the filter tank. To access these parts, you must remove the tank cover.
Refer to *page 9 for complete EXPLODED VIEW PARTS DIAGRAMS.
I. Power source instructions
1.The Above Ground filter pump system you have purchased is equipped with a standard electrical cord and plug
which should only be connected to a power outlet protected by a 30 Amp Ground-Fault-Circuit-Interrupter
(GFCI) that has been installed by a professional electrician and adheres to local codes and regulations.
2. To avoid electric shock, power cord extensions should not be used.
J. Positioning your filter system
 For best operation of this filter system with Above Ground pools, we recommend a skimmer be installed in
your pool. Either an integrated skimmer (built into the pool wall) or a suspended skimmer (attachment to
the pool wall).
 The installation area must allow an adequate safety margin to the pool wall.
 We recommend putting the filter system on a concrete slab or similar. Be sure the
installation is level.