Installation Guide
B. General Information
This manual provides information relating to the installation, utilization and maintenance of our filtration system.
We recommend that you read this manual in its entirety and keep it for future reference.
The pump included with the filtration system is a horizontal, centrifugal pump. For the pump to function correctly,
the water temperature must not exceed 35℃/95℉. The materials used in the pump have undergone stringent
hydraulic testing and electrical inspections.
The filter tank included in the filtration system consists of high-grade polypropylene (PP). It is manufactured as a
single unit (absolutely corrosion resistant and resistant to commercially available swimming pool chemicals).
(Prerequisite: Compliance with the standard recommended specifications for the pH- and chlorine value). It is
equipped with a tank drainage system. The filter tank comes ready to attach with an approved filter pump.
Read this manual carefully before installation. The filtration system and pump must be installed in accordance with
all federal and local codes and standards in effect for the area of installation.
We decline all responsibility for the consequences of failure to comply with the installation instructions. We
recommend that you comply with the power source instructions to avoid overloading the pump motor and/or
electric shock.
This filtration system is not intended for use by persons with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge.
Safety notes and information boxes should always be observed.
C. Safety Notes
Your filter pump was constructed and tested and left the manufacturing plant in technically operational condition. In
order to maintain this condition and ensure safe operation, the user should observe the notes and product
information contained in this technical manual. If there is any indication that safe operation is no longer possible,
the device is to be disconnected from the power supply and secured against accidental use.
This is the case when:
The device has visible damage.
The device no longer appears functional.
After long periods of storage in poor conditions.
If the power cord or other parts of this equipment are damaged, they have to be replaced by manufacturer or its
service agent or a similarly qualified person in order to avoid danger.
D. Damage during delivery
Your filter system has been carefully and professionally packed for delivery. Please check to ensure that the package
is undamaged and that all parts are in the box. If you purchased this product on order and the product was shipped
to you, ensure that delivery is complete. Damage to product as a result of shipping is not the responsibility of the
supplier and must be immediately reported to the shipper. The shipper assumes the liability for damages during
delivery, the supplier is not responsible for it.
E. Implied Warranty
The manufacturer warranties safe operation and reliability only under the following conditions:
The filter system is installed and operated according to the assembly and operating instructions.
Only original replacement parts are used for repairs or replacements (consumable & expendable parts do no
fall under the warranty).