Cambrian Round Above Ground Pool Instruction Manual VER.
this pool 1 m (8ft) 2
PRODUCT CONTENTS QTY Key 1 Mnf. NO.
GROUND PREPARATION The preparation of the ground is the most important step in the installation of the pool. Mark off your pool area by driving stakes. Have a helper hold a tape measure or a string and mark off the pool perimeter using flour or chalk. Remove sod inside the pool area to a distance of 30cm (1ft) beyond dimensions shown in the plot layout around entire perimeter of pool. 1 2 Use ground sheet to ensure that the grass doesn't penetrate the pool liner and cause damage.
1. Slide the Bottom Rail into the Metal Piece. IMPORTANT: Leave about 1cm (0.4'') gap between the 2 ends of the Bottom Rail. Repeat this process for all Bottom Rails. (See diagram 4) 6 6 7 4 7 8 9 10 5 When all the rails are slided into the Metal Pieces, it should form a complete circle and the diameter should be equivalent to the diameter of the pool itself. You can shorten or lengthen the gap distance between the 2 ends of Bottom Rails. (See Diagram 5) 7 the 2 ends of Bottom Rails.
10 15 16 11 6"H x 6" W 11 0.8" 15 cm (6") 15 12 SAND COVE 12 0.8" (6") 1 5 cm 0.8" 13 14 16 13 14 INSIDE OUTSIDE OUTSIDE INSIDE 13 SAND COVE Bottom Rail Place the Self Adhesive Tape over the exposed screw heads to seal them off.
21 Fix Rails ( 72°F ) 21 ( 0.4" ) Round Rail 22 then connect another Fix Rail, continue around the circle until all Fix Rails are all joined together. And finally apply the Round Rails to the Fix Rails. (See diagram 22) ( 60°F ) Fix Rail ( 3" ) 17 18 17 18 22 ( 3" ) 1.0CM (0.
23 26 23 24 24 26 Resin Metal Pieces at the top Make sure that the Metal Piece at the top is directly above the Metal Piece at the bottom. Place the remaining Metal Pieces on top of the Round Rails, between the Rail Joins and in alignment 24 with the Metal Pieces at the bottom. 25 17 9 9 Resin Top Resin Top Metal Pieces at the top. 25 14 13 Make sure that you place the Resin Top Platform with this curved edge outside the pool.
Diagram 28 RESIN 12 resin resin Resin Top Platforms. Resin Top Platforms 18 resin Fix with the screws provided.
For antirusting, all edges of cut out have to be covered by vinyl tape or rusting paint. Begin the installation of the through wall skimmer. Follow separate skimmer installations.
