Owners manual

6. Replace the charging port plug, pressing it rmly in place so water
does not seep into the port.
7. Remote control comes with a button cell battery (lithium CR2032, 3 volts) installed.
Pull clear plastic tab at side of remote to enable battery connection.
OPERATION
You can use the remote control or the button on the product to operate the fountain and light shows.
The remote control must be pointed directly at the product for it to function.
Press the button for the fountain and the underwater light shows.
Press the button for the upper and underwater light shows only (no fountain).
Press followed by button for the fountain only (no light shows).
Pressing the same button twice turns o that feature.
WARNING: Use the supplied battery charge adapter; DO NOT substitute with any other charger.
Never turn on the product while is charging.
IMPORTANT: Remove from pool when not in use or while cleaning so unit is not damaged by
skimmers or other devices. Do not submerse unit in water as this could damage the electronic
components.
Do not submerse unit in water as this could damage the electronic components. Remove from
pool when not in use or while cleaning the pool so unit is not damaged by skimmers or other
devices.
This product should be operated in at least 12 inches of water to get the maximum water height.
It is recommended to clean out the lter screen at bottom of unit periodically to ensure proper
water ow.
NOTE: The product only lights up in low light conditions. Ambient light may stop the lights from
turning on.
CLEANING& MAINTENANCE
Wipe dry with a soft cloth after use.
NOTE
• Do not mix old and new batteries.
• Do not dispose batteries into re.Batteries may explode or leak.
• Do not mix alkaline standard (carbon-zinc), or rechargeable
(nickel-cadium) batteries.
• Replace batteries ensuring the correct battery type, and as
a simultaneous act.
• Remove batteries if product is to be left unused for a long time.
• Clean the battery contacts and also those of the devices prior
to battery installation.
• The supply terminal is not to be short circuited (+) (-).
• Non-rechargeable batteries are not to be recharged.
• Batteries are to be inserted with the correct polarity.
• Remove exhausted batteries promptly and dispose of properly.