Installation Guide
STEP #5
The alarm is now ready to be attach
ed to the pool edge. Simply screw the
main alarm body into the edge.
Step #6
The water level of the pool must be adjusted and maintained in order for the
alarm to perform properly. The sensor throat tube should stick into the water
between 3 ΒΌ inches to 2 inches. If the wate
r should go far above or below
this level, the alarms effectiveness is greatly diminished. Maintain proper
water levels at all times. Never block or fill the air hole located on the back
of the alarms sensor throat. See Fig 4 and Fig 5.
Fig 4
STEP #7