Installation Guide

FIG 2
STEP #3
After the holes are marked, drill the two holes out using a 1/4 inch masonry drill.
**NOTE
** TAKE GREAT CARE USING POWER TOOLS AROUND
THE POOL. BE SURE THAT NO PEOPLE ARE IN THE POOL
DURING ANY PHASE OF THE INSTALATION. REMOVE ALL
POWERTOOLS FROM THE POOL AREA AS SOON AS THAT PHASE
IS COMPLETE.**
The holes need to be drilled 1 ¾ inches deep (Fig 2). The
easiest way to determine how deep to drill, measure 1 ¾ inches from the end of
the drill bit. Mark that location with a piece of tape. When drilling, stop when
the deck is level with the tape. The hole should now be 1 ¾ inches deep.
Remove all du
st and debris from the holes. Remove the nuts and washers from
the mounting anchors, and insert the mounting anchors into the previously
drilled holes. To mount on a wood deck, use ½ inch x 1 inch lag screws with ½
inch washers (not included) screwed direc
tly to the decking. To mount on a
metal rail, use ½ inch x 1 inch machine screws with ½ inch washers and nuts
(not included).