Installation Guide

The alarm will emit a long beep signifying that it is now in SWIM mode. The LED
in the transparent cover will now flash white, and will continue to flash white while
it is in swim mode. The pool can now be used without the alarm sounding. When all
swimmers exit the pool and the water becomes still, to protect the pool, the alarm
will automatically rearm itself again after 3 minutes of quiet surface. The alarm
will emit two beeps announcing that it is again in active protection mode and the
green LED in the transparent cover will flash at each 21 seconds. If immediate
protection is desired, do not wait until the water is calm; just move switches to
Reset/On position. This will instantly rearm the alarm.
If the alarm is sounding, immediately check the pool FIRST for any unsafe
condition. If the pool is clear of danger, push the switch button to work mode at
RESET position.
ON/OFF:
Move the switch to OFF, the pool alarm system will be cut off and stop working. To
turn on, move to ON, the system will be work again and emit one beep.
Low Battery Indicator
The alarm comes equipped with a low battery indicator. If the batteries need to be
replaced, the alarm will emit a chirp every 8 seconds. Refer to steps 4 for battery
replacement.
Winterization
When the pool is closed and covered for the winter, remove the main alarm body
from the pool and remove the batteries. Store the main alarm body indoors for the