Instructions / Assembly

SECTION . INSTALLATION
For existing pool
Drain water level to be below the returning fitting
1. Unscrew the light assembly head from the threaded wall flange. See figure 2
Warning: Please do not open the light assembly head. Open the head would avoid
the warranty.
2. Remove the existing eyeball fitting including eyeball, eyeball nut & eyeball base from
the return fitting on your pool wall See Figure 3
3. Screw the light assembly head in the threaded wall flange. Make sure the big rubber
gasket is installed to prevent the damage to the line. See Figure 4
4. Connect the special connecting fitting to the light assembly head see figure and make
sure an o-ring is installed and screw it tight enough to prevent any leaking.
See Figure 4
5. Disconnect the clamp on the hose.
Unscrew the hose adaptor from the existing fitting and screw to a special connecting
fitting see figure See Figure 5
6. Connect the hose to the hose adaptor.
7. Connect the quick wire connection as Figure 7
8. Mount the transformer on the vertical wall.
9. Plug the power cord’s 3-prong plug into an appropriate 110V GFCI protected
receptacle at lease 10 feet from the pool.
10. If the light is not on, press the switch below the transformer case. See Figure 8
Figure 2
Figure 3
Figure 5