Instructions / Assembly

ManualsBrandsBlue Wave ManualsOtherThru-Wall Light for Above Ground Pools

AquaLight & Return Water Flow

For Above Ground Pools

IMPORTANT SAFETY INSRTRUCTIONS

READ AND FOLLOW ALL INSTRUCTIONGS

SAVE THESE INSTRUCTIONS

Table of Contents

SECTION Ⅰ. IMPORTANT SAFETY INSTRUCTIONS…………………

SECTION Ⅱ. INSTALLATION………………………………………………

SECTION Ⅲ. REPLACING………………………………………………….

Before installing this product, read and follow all warning notices

and instructions accompanying this light. Failure to follow safety

warnings and instructions can result in severe injury, death, or

property damage.

WARNING

Important Notice

Attention Installer.

This manual contains important information about the installation,

operation and safe use of this product.This information should be

given to the owner/operator of this equipment.

Summary of content (6 pages)

PAGE 1
AquaLight & Return Water Flow For Above Ground Pools IMPORTANT SAFETY INSRTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONGS SAVE THESE INSTRUCTIONS Table of Contents SECTION Ⅰ. IMPORTANT SAFETY INSTRUCTIONS………………… SECTION Ⅱ. INSTALLATION……………………………………………… SECTION Ⅲ. REPLACING…………………………………………………. WARNING Before installing this product, read and follow all warning notices and instructions accompanying this light.
PAGE 2
SECTION I. IMPORTANT SAFETY INSTRUCTIONS When installing and using this electrical equipment, basic safety precautions should always be followed, including the following. 1、 This light can be installed on storable above ground or permanent above ground pools. 2、 A storable pool has a maximum water depth of 42 inches and is so constructed that it may be readily disassembled for storage and re-assembled to its original integrity. 3、 A permanent pool has a maximum water depth of over 42 inches.
PAGE 3
SECTION Ⅱ. INSTALLATION For existing pool Drain water level to be below the returning fitting 1. Unscrew the light assembly head from the threaded wall flange. See figure 2 Warning: Please do not open the light assembly head. Open the head would avoid the warranty. 2. Remove the existing eyeball fitting including eyeball, eyeball nut & eyeball base from the return fitting on your pool wall See Figure 3 3. Screw the light assembly head in the threaded wall flange.
PAGE 4
Figure 6 Note: Figure 7 Figure 9 Figure 8 For the wall mount fountains, please remove the eyeball and use the fountain
PAGE 5
adaptor as Figure 9 For new pool This light could be used as the returning fitting. Install the wall flange, gasket and octagonal nut as usual. See Figure Install the light following above procedure from step 3 to 11. SECTION Ⅲ REPLACING When the LED failed Disconnect the quick connector on the wire and unscrew the light assembly head from the wall flange and install a new one. Warning: Please do not open the light assembly head. Open the head would avoid the warranty.
PAGE 6