Specifications

34
Controller Basic Programming Mode
Programming the 'Temperature'.
1. The stored set ‘Temperature’ is displayed (default 350°F - 176.5°C)
with a flashing ‘F’ or ‘C’ for Fahrenheit or Celsius.
2. To change the temperature, press either;
a. 'Timer 1 - Up ’ to increase the temperature.
Or
b. 'Timer 3 - Down' to decrease the temperature.
3. When changing the temperature, the value changes at a slow rate for
the first 8 degrees and then at an increasing rate.
4. Press the Programme Key ‘P’ once the desired temperature is
reached, the temperature change will be accepted and the display will
step on to the next parameter.
Programming the Keypad 'Lock - Unlock’.
Refer to 'Programming the Password Protection' at the start of this section.
To Exit the Programming Mode.
To exit the Programming Mode at any stage of the programming, press and
holding the Programme Key ’P’ for approximately 3 seconds, or do not press
any key for 2 minutes. The display will revert to the ‘Idle Mode’.