Specifications

Oven Pilot Ignition

This oven is fitted with a pilot as a standard option and flame failure protection, which is incorporated by

way of a thermo-electric system for the main burner. Flame failure protection will shut off the gas supply

to the burner in the event that the pilot burner goes out, so that un-burnt gas is not expelled.

This is an

important safety feature which is slowly becoming law throughout the world

1. Open the oven door. Depress the thermostat control

knob and rotate anti-clockwise to the ‘PILOT’ position.

2. While holding the thermostat control knob depressed,

press the piezo ignition button to ignite the oven pilot

burner. Repeat Items 1 to 2 until the oven pilot is lit.

3. Release the thermostat control knob approximately 10-20

seconds after lighting the pilot.

4. Ensure that the pilot burner is alight by opening the pilot

viewing covers and looking through the pilot burner

viewing holes in the cast oven sole plate.

NOTE: Ensure that the pilot viewing covers are closed once the pilot is lit.

Oven Main Burner / Thermostat

1. With the pilot burner alight, rotate the oven thermostat control knob to the desired oven

temperature setting, this will regulate the gas supply to the oven burner and the oven main burner

will light from the pilot burner.

2. To turn the main burner ‘OFF’, simply turn the thermostat control knob to the ‘OFF’ position.

Turning the Oven to ‘Standby’ (Pilot ‘ON’ Only)

To turn off the oven burner / heating, set the oven thermostat control knob to the ‘PILOT’ position,

this will turn the oven ‘OFF’, but leave the oven pilot burner ‘ON’. In this position the pilot burner

will remain alight, but the main burner will not operate until the oven thermostat control knob is set

to a temperature.

Oven ‘Shut-Down’

To ‘Shut Down’ the oven, turn the oven thermostat control knob to the ‘OFF’ position. This will turn

‘OFF’ the oven and extinguish the pilot burner. To relight the pilot burner, refer to ‘Oven Pilot

Ignition’ in this section.

Operation

! IMPORTANT

DO NOT USE aluminium foil or trays directly on the cast iron sole plate(s).

NEVER block or cover the openings on each side of the sole plate(s).

Pilot Burner

viewing holes

Fig 4