Specifications
6
Assembly
All Models
All models come pre-assembled.
NOTE: This appliance is fitted with adjustable feet / castors to enable the unit to be positioned
securely and level. This should be carried out on completion of the electrical connection.
Refer to the 'Electrical Connection' section.
Optional Accessories (Refer to Replacement Parts List)
• Plinth Kit. For installation details, refer to the instructions supplied with each kit.
Electrical Connection
NOTE: ALL ELECTRICAL CONNECTIONS MUST ONLY BE CARRIED OUT BY AN QUALIFIED PER-
SON.
Each appliance should be connected to an adequately protected power supply and isolation switch mounted
adjacent to, but not behind the appliance. This switch must be clearly marked and readily accessible in
case of fire.
1. Check that the electricity supply is correct as shown on the
Rating Plate. (Refer to the dimension drawings for rating plate
location).
2. The supply terminal connections are located at the rear of the
the appliance. Refer to ‘Electrical Connections’ in the
‘Specifications’ section of the manual.
3. Remove the control panel to allow connection access for the
electrical supply.
4. Bring the supply cable up through the grommet at the back of
the appliance and through the compression type gland
provided on the rear of the main electrical switchgear panel.
5. Connect the mains supply to L1, L2 and L3 fuse carrier
connections for 3 phase.
6. Connect neutral and earth conductors to neutral stud and
earth stud respectively.
7. For all connections ensure that conductors are secure and
appropriately terminated.
8. Tighten the cable gland to secure against tension on the cable.
NOTE:
• This appliance must be grounded / earthed.
• Fixed wiring installations must incorporate an all-pole disconnection switch.
9. Correctly locate the appliance into its final operating position and using a spirit level, adjust the legs
so that the appliance is level and at the correct height.
10. Connect the power supply to the appliance.
11. Check that the electrical supply is as shown in the 'Specifications' section.
Installation
C
AUTION
:
•
This appliance is for professional use and is only to be used by suitably
qualified / trained persons.
•
Only qualified service persons are allowed to carry out installation and
servicing of this appliance.
WARNING:
THIS APPLIANCE MUST BE EARTHED. IF THE SUPPLY CORD IS DAMAGED, IT MUST BE REPLACED BY A SUITABLY
QUALIFIED PERSON IN ORDER TO AVOID A HAZARD.
Fig 1
Rating Plate
Location