Specifications

3
Specifications
Model Numbers Covered in this Specification
EP506 Electric Griddle Static Oven Range 900mm wide.
EP56 Electric Griddle Convection Oven Range 900mm wide.
General
A commercial heavy duty, 900mm wide, Electric Griddle, Electric Oven Range designed for modular
kitchens and constructed in an easy clean stainless steel external finish. The griddle elements are
constructed using stainless steel sheathed heating elements with dual thermostatic control zones.
The Griddle uses a 20mm thick griddle plate with the option of either ribbed or chromed mirror plate
options.
The range can be equipped with either a 900mm 6.5kW electric convection or static oven.
Electrical Supply Requirements
Electrical Connection
Electrical supply connection point is located at the rear of the appliance, approximately 74mm from
the right hand side and 501mm from the rear and 150mm from the floor.
When connecting a Blue Seal electric appliance to the main supply, ensure that the following is
carried out:-
• An isolating switch is fitted within 2m of the appliance, but not on the appliance and in
such a position that the user does not have to reach across the cooking surface.
• Supply cord shall be oil-resistant, sheathed flexible cable and not lighter than ordinary
polychloroprene or other equivalent synthetic elastomer sheathed cord (as per AS/NZS
3191 part 2.10.11. or IEC 60245-IEC-57) e.g. H05 RN-F Type.
• The branch supply line shall be individually overload protected to the correct current rating
and the supply chord shall be protected against any mechanical or thermal damage.
• A grommet is fitted around the wiring entry hole into the appliance.
• All wiring connections must be tight.
Refer to the appropriate wiring standards for the size of cable that is to be supplied to an appliance
for the current drawn on that line.
MODEL Fan Motor
EP506 18.5 kW
L1 - 24.6 Amps
L2 - 25.6 Amps
L3 - 25.6 Amps
---------
EP56 18.6 kW
L1 - 25.0 Amps
L2 - 25.6 Amps
L3 - 25.6 Amps
100W
3-Phase Connection
3P+N+E
400-415V, 50/60Hz
WARNING:
T
HIS APPLIANCE MUST BE EARTHED. IF THE SUPPLY CORD IS DAMAGED, IT MUST BE REPLACED BY A SUITABLY
QUALIFIED PERSON IN ORDER TO AVOID A HAZARD.