Specifications

-16-
ENSURE POWER IS SWITCHED OFF BEFORE SERVICING.
All servicing should be carrier out by a competent electrical serviceman.
TROUBLE SHOOTING
FAULT CAUSE REMEDY
Motor/Pump will not operate (no
motor/pump noise).
No power to unit.
Motor overload protection has
tripped.
Check supply cord connection.
Check power supply is on.
Check power is available at
supply.
Remove access plug from L/H
side panel and reset overload
switch (depress).
Motor/Pump will not operate
(motor/pump makes noise but will
not pump oil/shortening).
Motor / Pump stalled.
Blockage in pump or delivery
system.
Switch off then switch on again
either in forward or reverse
direction.
Refer operating instructions -
“Important points to remember”
page 12.
If unable to free blockage contact
an authorised service company.
All other faults refer to an authorised service company.