Specifications

26
Controller Advanced Programming Mode
The following Parameters can be accessed and adjusted in the Advanced Programming Mode:-

Timing Mode (Straight or Flexi cook time).
 Temperature Offset (Calibration Setting) -14° to +14°.
 Temperature Display Mode (Temp display or prompt display).
 Programming the Melt Cycle.
 Setting the Temperature Units (either °C or °F).
 System Programmable Default Settings.
1. Press the ‘ON / OFF’ Key to turn ‘ON’ the fryer
controller.
2. Press Programme Key ‘P’ and ‘Timer 1’ Key together to
enter ‘Advanced Programming Mode’.
3. If ‘LoC’ is displayed, password protection is turned ‘ON’ and
control panel is locked. Unlock the control panel, refer to
‘Controller Basic Programming Mode’ - ‘Entering the Controller
Basic Settings’, and repeat from Item 2 above.
Timing Mode
1. One of the following options will display:-
Straight Cook Time
Straight cook time refers to real time cooking.
Flexible Cook Time
Cook time can be automatically adjusted to
compensate for size of load being cooked.
2. To change ‘Timing Mode’, press either ‘Timer 1’ or
‘Timer 3’ Key.
3. Press Program ‘P’ Key to confirm options, the change
will be accepted and display will step on to
‘Temperature Offset’ parameter.
Press
Together
Factory Default Settings
TIMING MODE
TEMPERATURE
OFFSET
TEMPERATURE
DISPLAY MODE
PROGRAMMING
THE MELT CYCLE
SETTING THE
TEMPERATURE UNITS
IDLE MODE
from
-14° to +14°
either
't -1’ or 't -0’
either
‘CY L’, ‘CY.S’ or 'CY o’
either
'°F’ or '°C’.