Electric Frye rs E43 / E43E and E44 / E44E Service Manual 1 Blue Seal Evolution Series E43 / E44 Electric Fryers Revision 1/ © Moffat Ltd, January 2007
WARNING: ALL INSTALLATION AND SERVICE REPAIR WORK MUST BE CARRIED OUT BY QUALIFIED PERSONS ONLY. IMPORTANT: MAKING ALTERATIONS MAY VOID WARRANTIES AND APPROVALS.
Contents This manual is designed to take a more in depth look at the E43 and E44 electric fryers for the purpose of making the units more understandable to service people. There are settings explained in this manual that should never require to be adjusted, but for completeness and those special cases where these settings are required to change, this manual gives a full explanation as to how, and what effects will result. Section Page Number 1. Specifications .............................................
Blue Seal Evolution Series E43 / E44 Electric Fryers Revision 1/ © Moffat Ltd, January 2007
Specifications 1 External dimensions: E43 / E43E LEGEND - Electrical connection entry point Dimensions shown in millimetres.
1 Specifications External dimensions: E44 / E44E LEGEND - Electrical connection entry point Dimensions shown in millimetres.
Specifications 1 Electrical supply Power Supply Model Total Power Input Amps L1 L2 L3 17 kW 23.6 23.6 23.6 50 / 60 Hz 17 kW 23.6 23.6 23.6 3 P+N+E 50 / 60 Hz 17 kW 23.6 23.6 23.6 3 P+N+E 50 / 60 Hz 17 kW 23.6 23.6 23.6 Voltage Type Frequency E43 400-415 Vac 3 P+N+E 50 / 60 Hz E43E 400-415 Vac 3 P+N+E E44 400-415 Vac E44E 400-415 Vac Tank capacity E43 E44 27l 21.
2 Installation Installation Requirements NOTE: It is most important that this appliance is installed correctly and that operation is correct before use. Installation shall comply with local electrical and health and safety requirements. Blue Seal Deep Fryers are designed to provide years of satisfactory service, and correct installation is essential to achieve the best performance, efficiency and trouble-free operation.
Installation 2 Electrical Connection NOTE: ALL ELECTRICAL CONNECTIONS MUST ONLY BE CARRIED OUT BY A QUALIFIED PERSON. Each fryer should be connected to an adequately protected power supply and isolation switch mounted adjacent to, but not behind the fryer. This switch must be clearly marked and readily accessible in case of fire. The fryer is equipped with 32A fusing on L1, L2 and L3 supplies. Ensure that fuses are fitted (Type F1(NS) gG). 1. 2. 3. 4. 5. 6. 7. 8.
3 Operation 3.1 Description of controls Manual controls - E43 and E44 Temperature Control Knob Temperature Graduations 60°C to 200°C. Neon Indicator Power ‘ON’ Indicator. (When main power switch is ‘ON’). (White) Neon Indicator Heating ‘ON’ Indicator. (When thermostat is turned to a (Orange) selected temperature. Located Behind Main Access Door Temperature Operating the reset Cut-Out Reset resets the element. Switches (Press to operate). switch Mains Isolation Turns power ‘ON’ and ‘OFF’ to the unit.
Cleaning / Maintenance 4 WARNING: DO NOT USE FLAMMIBLE SOLVENTS AND CLEANING AIDS ON OR IN CLOSE PROXIMITY TO THE FRYER WHILST THE FRYER IS STILL HOT. C AUTIO N : Always turn off the electrical supply before cleaning the appliance. This appliance is not water proof. Do not use water jet spray to clean interior or exterior of this appliance.
4 Cleaning / Maintenance Locking Slide Locking Slide Fig 5 Fig 4 Daily Cleaning C AUTIO N : HOT OIL WILL BURN - DO NOT RUSH THIS JOB. 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. At the end of each day or at the end of each shift, if the frying schedule is heavy, the frying medium should be drained and filtered into a receptacle. Always filter the fryer when the cool zone under the elements is hot and liquid.
Cleaning / Maintenance 4 Weekly Cleaning NOTE: If the fryer usage is very high, we recommend that the weekly cleaning procedure is carried out on a more frequent basis. 1. 2. Proceed as for “Daily Cleaning” to drain and filter the tank. Do not refill the tank with frying medium until it has been cleaned as shown below. Fill the fryer with cold water to the normal fill level and add a high quality commercial cleaner that has been specifically formulated for fryers.
5 Trouble-shooting WARNING: 5.1 ALL INSTALLATION AND SERVICE REPAIR WORK MUST BE CARRIED OUT BY QUALIFIED PERSONS ONLY.
Trouble-shooting 5.2 5 Fault Diagnosis 5.2.
6 Service Procedures Section Page Number 6.1 Access ...................................................................................................... 22 6.1.1 .......................................................................................................................... 6.2 Replacement ............................................................................................ 22 6.2.1 ....................................................................................................
Service Procedures 6.1 Access 6.1.
7 Accessories 14 Blue Seal Evolution Series E43 / E44 Electric Fryers Revision 1/ © Moffat Ltd, January 2007
Exploded Parts Diagrams 8.1 8 E43 Single Tank Fryer 8.1.
8 Exploded Parts Diagrams 8.1.
Exploded Parts Diagrams 8 8.1.
8 Exploded Parts Diagrams 8.1.
Exploded Parts Diagrams 8.2 8 E43E Single Tank Fryer 8.2.
8 Exploded Parts Diagrams 8.2.
Exploded Parts Diagrams 8 8.2.
8 Exploded Parts Diagrams 8.2.4 E43E Electrical Assembly Item 34 35 36 37 38 39 40 41 42 43 44 45 Part No 015966 024018 021965 013977 024802 228660 025948 229033 020109 228375 228374 229582 020532 020256 Description CONTACTOR 100C09VA10 OVERTEMP THERMOSTAT 238°C LABEL - RESET MICROSWITCH INSULATOR DOOR MICROSWITCH E32/G32 TRANSFORMER WORKED TERMINAL BLOCK - 6 WAY FUSEHOLDER 6.
Exploded Parts Diagrams 8.3 8 E44 Twin Tank Fryer 8.3.
8 Exploded Parts Diagrams 8.3.
Exploded Parts Diagrams 8 8.3.
8 Exploded Parts Diagrams 8.3.
Exploded Parts Diagrams 8.4 8 E44E Twin Tank Fryer 8.4.
8 Exploded Parts Diagrams 8.4.
Exploded Parts Diagrams 8 8.4.
8 Exploded Parts Diagrams 8.4.4 E44E Electrical Assembly Item 34 35 36 37 38 39 40 41 42 43 44 45 Part No 015966 021965 024018 013977 024802 228660 025948 229033 020109 228375 228374 229582 020532 020256 Description CONTACTOR 100C09VA10 LABEL - RESET OVERTEMP THERMOSTAT 238°C MICROSWITCH INSULATOR DOOR MICROSWITCH E32/G32 TRANSFORMER WORKED TERMINAL BLOCK - 6 WAY FUSEHOLDER 6.
Wiring Diagrams 9.
9 9.
Wiring Diagrams 9.
E44E - Twin Tank Fryer 9.
Service Contacts 10 Australia VICTORIA - MOFFAT PTY HEAD OFFICE AND MAIN WAREHOUSE 740 Springvale Road Mulgrave VIC 3170 Spare Parts Department Tel (03) 9518 3888 Fax (03) 9518 3838 Free Call 1800 337 963 Fax (03) 9518 3895 NEW SOUTH WALES - MOFFAT PTY Unit 3/142 James Ruse Drive Rosehill NSW 2142 Spare Parts Tel (02) 8833 4111 Free Call 1800 337 963 Fax (03) 9518 3895 QUEENSLAND - MOFFAT PTY 30 Prosperity Place Geebung QLD 4034 Spare Parts Tel (07) 3630 8600 Free Call 1800 337 963 Fax (03) 9518 3895
10 Service Contacts United Kingdom BLUESEAL LTD Units 67 Gravely Industrial Park Gravely Park, Erdington Birmingham B24 8TQ England Tel 0121 327 5575 Fax 0121 327 9711 United States of America MOFFAT INC.
