Owner`s manual

Contact 1.800.762.1142 for assistance.
Do not return to place of purchase.
®
Owner’s manual: model 235000 outdoor patio heater
10
Step 7 – Attach Engine/Post to Platform
Insert platform cover over gas line and set on top of shroud cover.
Insert end of post without holes over gas line, being careful not to bend gas line.
Slide post through cover and into collar of platform so post rests completely on
platform.
Align the control panel with either the right or left leg attached to base.
Slide platform cover up to expose setscrews in platform and tighten bottom three
setscrews with hex (allen) wrench (M) supplied.
Make sure post is perpendicular to base.
Use top three setscrews to adjust post’s angle as necessary.
Tighten all six setscrews and slide cover back down.
Note: post must be perpendicular to base. Failure to do so will adversely affect burner
performance.
Step 6 – Attach Engine to Post
Lay engine assembly on its side, using shipping carton for support.
Remove and save control knob.
Remove and save engine access panel by unscrewing black thumbscrew from bottom
of access door.
Disconnect wire from igniter by gently pulling wire from back of box.
Align 4 holes in top of post with 4 holes in bottom of engine.
Note: one hole is at a different level than the rest. Make sure that all 4 holes line up
properly.
Insert 4 small screws (A) enough to hold engine in place. They will be fully tightened at
the end of step 8.
Note: do not replace engine access panel until step 13.