User manual

58
Maintenance Storage Tips
3. Remove the battery from the battery compartment and separate it from the wiring connector.
4. Connect a new 9-volt battery to the wiring connector and fit the battery into the compartment.
5. Fit the center tab on the battery cover into the slot on the housing and pivot the cover down.
6. Slide the battery cover into position so that it locks into place on the housing.
Note the following safety warnings when installing batteries.
!
WARNING
Risk of personal injury or harm.
• Always make sure the battery polarities (“+” and “–”) are correct when installing.
• Do not expose batteries to excessive heat.
• Use batteries from a reputable manufacturer only.
• Do not try to recharge batteries that are not specifically designed to be recharged.
• Do not allow children to install batteries unsupervised.
• Follow the battery manufacturer's instructions as to proper handling, storage, and
disposal of batteries.
Improper use of batteries can result in personal harm.
8.3 Storage Tips
When storing your MICROSCAN unit, remember the following:
• Always turn the tool off.
• Remove the battery if the tool is going to be in storage for an extended period of time.
• Make sure the tool will be kept within the recommended storage temperature range. See
“Technical Specifications” for details.