User manual

44
Data Parameters Long Parameter Names
TP/TP_B/TP_C
Shows the absolute throttle position. The output signal is a
proportional percentage to the input voltage (when proportional) or
100% minus the proportional percentage (when inversely
proportional).
See PID $45 for the relative position.
TP_R
Shows the 'learned' throttle position. Due to the 'closed throttle
offset', Wide Open Throttle will be much less than 100%.
See PID $11, $47 and $48 for the absolute position.
VPWR
Shows the power input to the ECM. This is not automatically equal
to the battery voltage!
VSS
Shows the vehicle speed as obtained from a sensor or as
calculated by the ECM (using other inputs).
WARM_UPS
A warm-up cycle is valid if the coolant temperature rises, after
starting the engine, at least 22 °C/40 °F and reaches at least 70
°C/160 °F (60 °C/140 °F Diesel). The maximum number is 255. To
set to 0, reset all DTCs.
Table 6-2 Short parameter names (sheet 4 of 4)
Parameter Description for short parameter