User manual

42
Data Parameters Long Parameter Names
EQ_RATxy
Status of the oxygen sensor in V or as a ratio. Designed for linear
or wide-ratio oxygen sensors.
See also PID $14 and up or $34 and up.
EVAP_PCT
Shows the status of the Evaporative Purge Control Valve between
0% (no flow) and 100% (max. flow, max. duty cycle)
EVAP_VP
Evaporative system vapor pressure, if used by the control module.
Can be obtained from a fuel pressure sensor in the tank or in the
evaporative system vapor line.
FLI
Shows the nominal fuel tank liquid fill capacity. For gaseous fuels
the percentage of usable fuel capacity is shown. Can be obtained
directly from a dedicated sensor or calculated by the ECM from
other sensor signals.
FRP
Shows the fuel rail pressure at the engine relative to the
atmosphere (gauge pressure).
FRP_REL
Shows the fuel rail pressure at the engine relative to the intake
manifold vacuum.
FUELSYSx
Fuel System 'x' does not normally refer to injector banks. It is
intended to represent different fuel systems (for multi-fuel vehicles)
that can independently enter and exit 'Closed Loop'. 'Closed Loop'
means the fuel control system uses the oxygen sensor signal.
Banks of injectors on a V-engine are generally not independent
and use the same closed loop criteria.
IAT
Shows the intake manifold air temperature as obtained from a
sensor or as calculated by the ECM (using other inputs).
LOAD_ABS
Value is presented as a percentage and ranges from 0 to 100 for
naturally aspirated engines, and from 0 to 400 for boosted
engines.
On boosted engines the actual figure displayed is dependant on
how much boost is used. The higher the boost used, the higher
Absolute Load Value will be.
LOAD_PCT
The ECM calculates the engine load by dividing the actual
manifold airflow volume (Otto engines) or actual fuel flow (Diesel
engines) by the maximum possible volume with a factor for
pressure and temperature compensation. Correlates with the
engine vacuum. Value is presented as a percentage and ranges
from 0 to 100.
LONGFTx
Shows the correction used by the Closed Loop and Open Loop
fuel algorithm at the moment this parameter is requested. Negative
values indicate a 'lean' condition, positive values a 'rich' condition.
0% correction will be shown if no correction is used in Open Loop.
MAF
Shows the flow rate of the intake air as measured by the Mass Air
Flow (MAF) sensor.
MAP
Shows the absolute pressure in the intake manifold as measured
by the MAP sensor.
Table 6-2 Short parameter names (sheet 2 of 4)
Parameter Description for short parameter