Owners manual

21. Remove the temperature sensor on the driver’s
side. Turn it around and reinstall so that it is
pointing up not down.
22. Trim the air dam 1 7/8” down from the top and all
the way across. Do this on both sides.
21
21
Ô
Ô
22
22
Ô
Ô
Ô
Ô
1 7/8”
Page 8 of 14 405-0006 Rev. C 9/14/10
Ô
Ô
19. On the driver’s side, use an 8MM socket to remove
the hex nuts holding the horn bracket. Unplug the
wire (gray arrow) and set the horn bracket aside to
install later.
19
19
Ô
Ô
Ô
Ô
20
20
20. Underneath on the belly pan, use a 13MM socket
to remove the two hex nuts. Do this on both sides.
Take the brace out (gray arrow) in order to remove
the bumper. Set all aside to reinstall later. Do this
to both sides.
Ô
Ô
Ô
Ô
Ô
Ô
2008 VW EOS
Installation Instructions
BX3828