Owners manual

BX3827
2000-05 VW Jetta TDI
Installation Instructions
292-3032 Rev. B Page 5 of 9 4/8/10
9
7
7. Remove two (2) bolts from the horn below the
driver’s side of the bumper using a 13MM socket.
Unplug horn. Set the horn and bolts aside to
reinstall later.
9. On the passenger side, using a 10MM wrench,
remove the two (2) bolts holding the turbo cooler.
Tie the turbo cooler back toward the front tire out
of the way.
10
10. To begin removing bumper, remove two (2) bolts
(white arrows) with a 13MM socket, and also
remove two (2) torx head bolts (gray arrows) using
a 30 Torx socket. Do this to both sides and set
aside to reinstall later.



8. On the driver’s side, use the reciprocating saw to
cut along the lower bumper contour, as shown in
the photo.


8
Using a good quality paint, spray cut edges
of frame to prevent rusting.




